Skirting boards collect a lot of dust and might be marked by normal usage in a room because of their location.

Your skirting boards will likely need a bit more attention than other parts of the house.

What you’re going to need

 

  • Soap made with a sugar solution
  • Sponge
  • Sandpaper
  • Primer
  • Applying paint to the skirting board
  • brush with a diameter of two inches
  • a swab of paper
  • Duct tape

 

Begin from the beginning

 

Choosing a paint color is the first step. Skirting boards follow the same standards as any other part of an interior design project… However, regulations may be violated at any time. In general, your skirting boards’ color should match the color of your wall. The darker the color of the skirting board, the more contemporary the room will seem, while the lighter the color, the more spacious the space will appear.

Using a gloss finish on skirting boards is a good idea since they are more durable than other treatments. Those who like a more modest look might choose for matte finishes, which can withstand minor scratches and dings.

Walls and skirting boards should be painted first and then the rest of the room, respectively. When decorating, it’s a good rule of thumb to start at the top and work your way to the bottom. You won’t have to worry about dripping paint spoiling your freshly painted skirting boards if you paint a feature wall first. The ceiling should come first, followed by the walls, skirting board, and wood trim.

Painting your skirting boards? Here’s everything you need to know.

The water-based nature of our paint makes it easy to clean up if it spills on the floor or carpet. To be safe, here are a few pointers for painting skirting boards without splattering paint all over the place.

You should tape down a dust sheet as near to the skirting board as possible if you are painting the skirting boards and there is carpet underneath them. You may also use a piece of cardboard folded in half and tucked beneath the skirting board to secure it.

Clean your skirting boards using a sugar soap solution and a sponge. You must remove any debris, dust, and grease from the surface before painting

Painting your skirting boards without first sanding them is not recommended. Sanding improves the adhesion of the paint and allows for less coats to be used. The skirting board should be lightly sanded and the dust wiped away. Allow it to totally dry.

How to paint your skirting boards?

Prime the surface once the skirting boards have dried to provide a professional appearance. Wipe any excess primer off the paint tub rim with a 2″ brush before applying the second coat of paint. Make sure the brush isn’t too thick with primer, since this will increase the likelihood of drips and streaks.

Your skirting board begins at the top. Start at one corner of the room and work your way to the other while holding the brush at a 45-degree angle.

  • Be cautious not to leak any on the floor as you finish the bottom piece of the skirting board.
  • Fill in the gaps.
  • It takes between two and four hours for our primer to fully dry.
  • Apply the first layer of paint as soon as the priming is dry. Apply it the same manner you applied the primer. It’s probable that you’ll need two coats to get the optimum effects, but always double-check the label.
  • To remove the tape while the paint is still wet, but to keep the dust sheet in place until the paint is entirely dry, remove the tape while the paint remains wet.